Optimización del modelado CAD para el análisis del patrimonio histórico molinar

Miguel Castro García

Spain

Universidad de Jaén

Departamento de Ingeniería Gráfica, Diseño y Proyectos de la Universidad de Jaén. España

José Ignacio Rojas-Sola

Spain

Universidad de Jaén

Departamento de Ingeniería Gráfica, Diseño y Proyectos de la Universidad de Jaén. España

Mª del Pilar Carranza Cañadas

Spain

Universidad de Córdoba

Departamento de Ingeniería Gráfica y Geomática de la Universidad de Córdoba. España

Submitted: 2016-02-04

|

Accepted: 2016-02-04

|

Published: 2011-04-15

DOI: https://doi.org/10.4995/var.2011.4634
Funding Data

Downloads

Keywords:

CAD, Modelling 3D, Polygon mesh, Nurbs mesh

Supporting agencies:

Junta de Andalucía

Abstract:

The use of CAD techniques (Computer-Aided Design) is a normal practice and is considered a mandatory task in the graphical recovery that involves any study of industrial archaeology: Therefore, it suggests the importance of a successful modelling CAD has in the different studies and analysis, for example, simulation of a physical process by Finite Element Method (FEM). In this sense, the communication is intended to analyze critical issues and meshing surfaces of the 3D model presented in the research work of graphic recovery of any example of heritage industrial, for example, the windmills of the Community of Andalusia (Spain).
Show more Show less

References:

AURICCHIO, F. (2010): “The importance of the exact satisfaction of the incompressibility constraint in nonlinear elasticity, mixed FEMs versus NURBS-based approximations”, en Computer Methods in Applied Mechanics and Engineering, nº199, pp. 314-323. https://doi.org/10.1016/j.cma.2008.06.004

DÖRFEL, M.R. et al. (2010): “Adaptative isogeometric analysis by local h-refinement with T-Splines”, en Computer Methods in Applied Mechanics and Engineering, nº199, pp. 264-275. https://doi.org/10.1016/j.cma.2008.07.012

ECHTER, R. et al. (2010): “Numerical efficiency, locking and unlocking of NURBS finite elements” en Computer Methods in Applied Mechanics and Engineering, nº199, pp. 374-382. https://doi.org/10.1016/j.cma.2009.02.035

QUIROZ LARREA, L. et al. (1994): “Conexión no conforme de mallas de elementos finitos mediante una formulación híbrida”, en Mecánica Computacional, vol. 14, pp. 520-528.

MATEUS SANTIAGO, S. (2007); “Ajuste con NURBS a una Malla Cuadrilateral Regularizada”, en Avances en Sistemas e Informática; nº3, pp. 109-115.

PÉREZ ARRIVAS, F. (2007): “Modelado Geométrico del Casco de un Buque”, en Comunicación al Congreso Internacional de Ingeniería Gráfica, INGEGRAF 2007.

SEDERBERG, T.W. et al. (2004): “T-spline Simplification and Local Refinement”, en ACM transactions on graphics, nº3, pp. 276-283. https://doi.org/10.1145/1015706.1015715

Show more Show less